Bluetooth built-in: fully configurable with a tablet or smartphone 
Low battery voltage alarm 
Low battery voltage cut-off and restart levels 
Dynamic cut-off: load dependant cut-off level
Output voltage: 210 - 245V
Frequency: 50Hz or 60Hz
ECO mode on/off and ECO mode sense level
Alarm relay 
 
Monitoring:
In and output voltage, load and alarms 
 
VE.Direct communication port
The VE.Direct port can be connected to a computer (VE.Direct to USB cable interface cable needed) to configure and monitor same parameters. 
 
Proven reliability 
The full bridge plus torodial transformer topology has proven its reliability over many years. The inverters are short circuit proof and protected against overheating, whether due to overload or high ambient temperature. 
 
High start-up power 
Needed to start loads such as power converters for LED lamps, halogen lamps or electric tools. 
 
ECO mode
When in ECO mode, the inverter will switch to standby when the load decreases below a preset value. Once in standby the inverter will switch on for a short period every 2.5 seconds (adjustable). 
If the load exceeds the preset level, the inverter will remain on. 
 
Remote on/off
A remote on/off switch or relay contact can be connected to a two pole connector. Alternatively, the H terminal (left) of the two pole connector can be switched to battery plus, or the L terminal (right) of the two pole connector can be switched to battery minus (or the chassis of a vehicle, for example).
 
To transfer the load to another AC source: the automatic transfer switch 
For Victron low power inverters it is recommended to use the Filax Automatic Transfer Switch. The Filax features a very short switchover time (less than 20 milliseconds) so that computers and other electronic equipment will continue to operate without disruption. Alternatively use a Mulitplus with built-in transfer switch.